Sunday, August 19, 2012

Gen Con Steampunk Layout 1

Start by cutting out the center part of the large B&T paper. Leave the border in tact as much as possible and cut along the circles in the corners.
Assemble the left side with the border piece tucking under the left lower corner B&T paper.
Distress the paper as desired with the Edge Distresser.
Layer the bamboo gears cut from the cricut using 3D Foam Tape
Stamp the upper left corner with Cocoa and the title at the bottom. Add the Cameo Cricut die cut to the lower right corner.
Ink distress the Flutter in Bamboo and add using 3D foam tape to just the middle of the Flutter.
Add Glitz Gel as desired.
Add the zipstrips below the photo mats.
Add the Flower stems under the gears on the right side

Stamp clock and key in cocoa in the lower right corner
Stamp the clock in the lower left corner beneath gears.
Add buttons as desired


No comments:

Post a Comment